Video Distribution Amp & Line Phase Indicator

VDA-601
Video Distribution Amplifier

  • 6 Output
  • Looping Input
  • Adjustable Gain
CCIR/PAL Compatible!
VDA - 601 front view
The VDA-601 is a high quality one input looping to six output video distribution amplifier. This high performance amplifier contains a built-in switch in the rear of the unit for selecting looping or 75 ohm termination on the video input. All video outputs are short circuit protected and each can drive a 75 ohm terminated load. Unused video outputs need not be terminated to maintain top performance of the other terminated video outputs.

A level adjustment for the video outputs is accessible through the front panel. This adjustment gives full range amplification or attenuation depending on the system requirements. All outputs are adjusted simultaneously by this one control.

All video outputs are DC coupled to maintain high quality video outputs. All specifications are measured at 75 ohm termination, but the VDA-601 will drive any load without effecting any other video outputs. Each video output has a 75 ohm resistor in series with the main output amplifier stage. Lower terminations will result in a lower video output and higher values will yield a higher video output.

SPECIFICATIONS
Input Level.....................................0.5_2V P-P
Output Level...................0.0_2V P-P Adjustable
B/W..................................10 Hz _Mhz +/- 1dB
S/N.................................................60 dB min.
Output Impedance...............................75 ohms
Power Supply.....................9_12VDC @ 300mA
Power Consumption......................3 Watts max.

Controls:

Video Level...............Screwdriver single turn pot
Loop/terminate................................Slide switch

Connectors:

Video Input..........................................BNC (2)
Video Output........................................BNC (6)
Power........................DC Coax 2.1mm x 5.5mm

Mechanical:

Case..Painted Aluminum; 4.7"W x 4.3"D x 1.75"H

Transformer:

Wall Cube..................................9 VDC @ 300mA

UL/CSA Rated with 6' cord

Note: Video ground floating with respect to power ground. Do not connect the VDA-601 to a common power supply with any other equipment
The compact metal enclosure maintains top performance in all kinds of mounting situations. A small UL/CSA rated wall transformer supplies 9VDC to the unit. VDA - 601 rear view
LPI Pocket V-Phase Indicator
The LPI is a low cost test instrument that can easily align line locked cameras for flawless video switching. This battery power pocket sized unit is a must for every installer.
CCIR/PAL
Compatible!
Features:
  • Lag/Lead Detection Yellow LEDs
  • In-Phase Detection Green LED
  • 180 Out Indication
  • Video Sync Detection Green LEDs
  • Uses standard 9V Alkaline Batter
  • Two BNC Inputs (Unterminated)
  • 1.0V P-P to 2.5V P-P Video Input
  • Detection Range
LPI - V-Phase Indicator
Back

AVE Thailand Co., LTD.
147 Soi OnNut44, (Sampheenong Villa), Sukhumvit 77Rd., Suanluang, Suanluang, Bangkok 10250 Thailand.
Tel: +662 331 9285 ,
+662 331 9364 and +662 742 0221
Fax: +662 331 9365
Mobile: +81 838 6805
Email: ave@avethailand.com